If you want to use an existing coax cable for the IP camera without having to pull a new network cable, Highwire from Veracity is the right solution - camera video over coax cable.
It allows transmission of IP signals from surveillance cameras up to 300 metres, and up to 500 metres when using a higher quality coax cable.
Installation is very simple: connect the camera to the first Highwire, connect one Highwire to each end of the coax cable and then connect the 2nd Highwire to your PC, server or the device you want to use to record the camera.
Highwire supports all cameras, up to the highest image resolution. It configures itself automatically after connection. If required, several cameras connected upstream to a switch can also be transmitted.
Scope of delivery: 1x VHW-HW (transmitter side or receiver side), please order power supply separately! Price applies to 1 piece VHW-HW
Our support team will be happy to inform you about the possibilities of data transmission via coaxial cable on request! You can reach us at +49 2433 / 964 25 80, or you can send us a contact form.
We look forward to your enquiry!
Technical details Highwire
Connection Koax : BNC 75ohm
Impedance : 75ohm (RG59 oder ähnlich)
Kable length: Up to 250m for full data rate (or up to 350m at reduced rate)
Data throughput max : 200Mbps (total up + down)
Auto-adaptation to cable conditions
ETHERNET INTERFACE
Connector type : RJ45
Cable type : Straight through or cross-over, auto detected
Rates supported : 100BaseT / 10BaseT, full/half duplex with auto negotiation
LED INDICATORS Green – Constant : Power OK
Full HIGHWIRE data link Green – Slow : Power OK
Auto-adapted HIGHWIRE data link Green – Blink : Power OK
no HIGHWIRE link Green – Off : No power
Amber – Constant : Ethernet link On
Amber – Blink : Network traffic
POWER SUPPLY
Connector type : Screw terminals with detachable plug
Power supply type : IEC Class II isolated only
Operating voltage : Nominal 12V DC (9-24V working range) or 24V AC (type and polarity auto detected)
Supply current : 200mA (12V), 100mA (24V)
ENVIRONMENTAL
Operating temp.: -10ºC to 50ºC
Relative humidity : 85% non-condensing
Grounding : Chassis should be grounded and is connected to the BNC shield
Dimensions : L 104mm (83mm excl. conns.) x W 54mm x H 23mm
Weight : 110g
Compliance : CE, FCC, RoHS
Please find additional documentation here:
Data sheet
Please find additional photos and videos here:
There are no reviews yet.