Veracity VHW-HW set IP coax converter

Item number: A10074

Highwire-Set to transmitting IP camera signals via coax cable
Show description 
279,95 €

including 19% VAT., no shipping costs

 
Available now! (1 - 2 workdays)
Description

If you want to use an existing coaxial cable for the IP camera without pulling a new network cable, the highwire is the right solution.

It allows a transmission of up to 300 meters, using a higher-quality coaxial cable up to 500 meters.

The installation is simple: Connect the camera to the first highwire, connect a highwire to one end of the coaxial cable, and then connect the 2nd highwire to your PC, server, or the device you want to use to capture the camera.

Highwire supports all cameras, up to the highest image resolution. It automatically configures itself after a successful connection. If required, several cameras, which are connected upstream of a switch, can be transmitted.

This set can also be used for VoIP telephones and access point devices.

The product comes with a special complete set and includes: 2x VHW-HW (transmitter side / receiver side), 2x power supply 12 Volt for transmitter / receiver.

Technical details
Connection coax cable : BNC 75 Ohm
Impedance : 75 Ohm (RG59 or similar)
Cabel length: Up to 250 meter with full data rate (or up to 500 meter with reduced data rate)
Max data rate: 200Mbps (up and down)
Auto-Adapting


Network connector

Connection : RJ45
Cable type: Straight or Cross-Over (Auto detection)
Supported data rate: 100BaseT / 10BaseT, Full/Half-Duplex
LED indication: Green - steady: Power OK
HIGHWIRE Data link Green ? slow blinking : Power OK
Auto-Adaption HIGHWIRE Data link Green ? flashing: OK
No HIGHWIRE link Green ? off : No power
Orange steady: Ethernet-Link On
Orange flashing : Network communication


Power supply

connection: Screw-terminal with connector
Supply : IEC class II isolated
Working power: Nom 12V DC (9-24V) or 24V AC (Auto-detection for type and polarity)
Consumption: 200mA (12V), 100mA (24V)


General

Working temperature.: -10ºC - 50ºC
Humidity: 85%
Ground: Please ground the chassis, internal connection with BNC shield
Dimension: L 104mm (83mm w/o connector) W 54mm x H 23mm
Weight: 110g
Photos & videos
Please find additional photos and videos here:
Ratings

 0  Ratings

Write your first review and help others with their purchase decision:

Question on item